To Learn More Contact
A very popular S&S design from the post World War II era, WILD SWAN was completely rebuilt and has been extremely well maintained by her owners of 25 years. These were very competitive boat in their day and I am sure she is still a threat on the Classic race course, but sitting aboard her last weekend, I couldn’t help notice how comfortable the cockpit was for sailing and socializing. The deep seats with high combings at a comfortable angle were a nice change from the shallow, deck level seats typical of many of the boats from this era. If you are in the market for a comfortable cruising classic with a good turn of speed for classic racing, come take a look at WILD SWAN. She is worth the trip.
PACUYS - AYS would love to guide you through a personal showing of this 40' Sparkman & Stephens Brasil & Makinac Class Sloop by Fisher Boat Works 1947. This yacht for sale is located in Havre de Grace, Maryland and priced at $125,000. For a showing please contact us by filling out the form on this page and we will get back to you shortly!
Sparkman & Stephens
Brasil & Makinac Class Sloop by Fisher Boat Works
Length at Waterline: 27'7.5"
Total Power: 41
Fresh Water: Portable
Mahogany planking over oak frames. The transom has an aft rake and a nice shape, painted mahogany over cedar, and has been extensively gone over and repaired during the rebuild. Planking is one inch thick Honduras mahogany. keel is oak/lead. The lead is 8,200 lbs. The rudder is oak with bronze strapping.
Structural Members: 1 inch Honduras mahogany planking. 1 ¾ by 2 inch mostly laminated oak frames, on 11 inch centers, glued with West epoxy mixed with chopped cotton. Fir bilge stringer. 5/16” white cedar hull ceiling. 1 inch by 1 ¾ inch cabin top beams on 9 inch centers. The cabin top is a double layer of fir plywood covered with canvas. The deck is 3/8 inch Ocoume plywood covered with 5/8 inch teak; it had been plywood covered with canvas. 1 ¼ inch by 1 7/8 inch deck beams are on 10 inch centers. 2 ½ inch by 4 inch clamp. Metal rods are run athwartship every four or five deck beams to tie the hull and inner cabin together. 1 ¾ inch floor timbers on 11 inch centers. Floor timber thickness and spacing varies in the length of the vessel. Stainless steel cross strapping is on the inner hull.
Fastenings: 16 bar by 2 inch bronze wood screws are used for plank fastenings replacing the original 14 bar fastenings, in part, to help clean up the old holes for the screws as well as the bungs in the original planking.
The main salon features a berth to port and a berth to starboard. Both berths are six feet six inches long. A fold down varnished table is mounted to the forward main salon bulkhead and offset to port. There are several lockers outboard of the berths, and a shelf. The galley area with the stove is aft to port with storage outboard, aft, and under. The galley sink is inboard of the stove to port. Opposite to starboard is the ice chest and VHF. The ice box is quite large, allowing room for a lot of ice as well as goods. There is storage outboard of the ice box to starboard, and storage aft to starboard under the cockpit. The cabin sole is varnished holly splined teak over plywood. The companionway steps are centered aft with non-skid treads. The ladder is hinged to fold up for access to the engine behind it. The bulkheads, hull ceiling, cabin top overhead, much of the planking, and berths, are painted white, and the cabin sides, sole, drawer faces, and lots of trim are varnished mahogany. Much of it has been completely rebuilt, and all is in keeping with a fine yacht in appearance and quality.
Next forward of the main salon is a head with a sink, toilet, and mirror. There is storage outboard, and a small locker is next to the head/sink. Two lockers are opposite the head to starboard.
In the forepeak is a v-berth with storage areas under the berths, and drawers in the vertical areas in the triangle aft. There is a small seat mounted in the forepeake as well.
Ventilation: Two Dorade boxes are on the cabin top, and a vent is over the galley area. One removable vent plate is on the fore deck. Most of the locker doors have ventilation cutouts in the shape of an anchor.
This listing is presented to you courtesy of a member of the International Yacht Brokers Association and may be centrally listed with another broker. It is offered as a convenience by this broker/dealer to its clients and is not intended to convey direct representation of a particular vessel.
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.